 |
Step 2 |
|
1. Using the wire cutter, cut 2- to 8-inch lengths
from the solder. Approximately 50 pieces will be needed to
trim a medium-size pumpkin like the one shown above.
2. Using the photographs as guides, twist the
solder lengths into desired shapes. Use needle-nose pliers
to start bending the end of the solder into a small loop.
You can bend the solder lengths into coils, S-shapes,
zigzags, or whatever shape you wish. Leave an inch at the
end of the solder to bend perpendicular to the shape. This
end of the solder will poke into the pumpkin to hold the
solder shape in place.
|
;)
;)
;)